Use of non-metallic materials in high pressure oxygen breathing gas applications

Use of non-metallic materials in high pressure oxygen breathing gas applications

As part of a programme of harmonization of industry standards, the European Industrial Gases Association (EIGA) publication, EIGA Doc 73, Use of non-metallic materials in high pressure oxygen breathing gas applications, has been used as the basis of an internationally harmonized gas association’s publication on this subject. This publication is intended as an internationally harmonized publication for the worldwide use and application by all members of Asia Industrial Gases Association (AIGA), Compressed Gas Association (CGA), European Industrial Gases Association, (EIGA), and Japan Industrial and Medical Gases Association (JIMGA). Regional editions have the same technical content as the EIGA edition, however, there are editorial changes primarily in formatting, units used and spelling. Regional regulatory requirements are those that apply to Europe.

This publication addresses high pressure oxygen breathing gas systems with pressures greater than or equal to 30 barg (435 psig) and with an oxygen content above 23.5% by volume. It applies in particular to non-metallic materials which if they ignite or decompose could contaminate the gas stream with toxic products. The recommendation of this publication can be beneficially applied at pressures lower than 30 barg (435 psig).
This publication is to be applied to high pressure customer breathing installations (for example, hospitals and homecare) where the ignition of non-metallic materials creates an immediate risk of inhalation of toxic products. This includes all elements of that installation from cylinder valve to point of use.
This publication is not intended to apply to cylinder filling centres though it is recommended that the toxicity issue is addressed by a risk assessment of the filling system design.

Table of Contents

1 Introduction
2 Scope and purpose
2.1 Scope
2.2 Purpose
3 Definitions
3.1 Publication terminology
3.2 Technical definitions
4 Safety considerations
4.1 System design
4.2 Cleanliness
4.3 Material susceptibility and toxicity risks
5 Recommendations
5.1 Risk analysis
5.2 Specific recommendations
6 References
7 Additional references

EIGA 2017

Allegati

Allegati

	Descrizione	Lingua	Dimensioni	Downloads
	Use of non metallic materials in high pressure oxygen breathing gas applications EIGA 2017	EN	288 kB	2482