Guide to the Radio Equipment Directive 2014/53/EU

Version 05 June 2018

This Guide is intended to serve as a manual for all parties directly or indirectly affected by the Radio Equipment Directive 2014/53/EU (RED). It should assist in the interpretation of the RED but cannot take its place; it explains and clarifies some of the most important issues related to the Directive’s application. The Guide also aims to disseminate widely the explanations and clarifications reached by consensus among Member States and other stakeholders.

This Guide will be reviewed periodically to be kept up to date.

This Guide is publicly available, but is not binding in the sense of a legal act adopted by any of the EU institutions, even if the word 'shall' is used in many parts of this Guide. In the event of any inconsistency between the provisions of the RED and this Guide, the provisions of the RED prevail.

The services of the European Commission undertake to maintain this guide to ensure that the information is accurate and up to date. Errors brought to the Commission’s attention, will be corrected. However, the Commission accepts no responsibility or liability whatsoever with regard to the information in this guide. The information:

- is of a general nature only and is not intended to address the specific circumstances of any particular individual or entity;
- is not necessarily comprehensive, complete, accurate or up-to-date;
- sometimes refers to external information over which the Commission has no control and for which the Commission assumes no responsibility;
- does not constitute legal advice.

Finally, attention is drawn to the fact that all references to the CE marking and EU Declaration of Conformity relate to the RED only and radio equipment only benefits from the free circulation in the Union market if the product complies with the provisions of all the applicable Union legislation. Reference is therefore made, whenever necessary but not always, to other EU legal acts.

...

________

Contents
Introduction
1 Scope
General
Geographic application
Application in non-EU States, countries & territories
Mutual Recognition Agreements (MRAs)
1.2.2.1 MRA with Switzerland
Agreements on Conformity Assessment and Acceptance (ACAAs)
Placing on the market
Putting into service
Special measures regarding radio equipment at trade fairs, etc
Radio equipment
What is radio equipment?
What is explicitly excluded from the scope of the RED?
1.6.2.1 Radio equipment exclusively used for activities concerning public
security, defence, State security
1.6.2.2 Radio equipment used by radio amateurs
1.6.2.3 Marine equipment
1.6.2.4 Airborne equipment
Specific example: drones
1.6.2.5 Custom-built evaluation kits
Specific cases / examples (non-exhaustive)
1.6.3.1 Non-radio products which function with radio equipment/electrical and electronic equipment with non-electrical products..14
1.6.3.2 Infrared devices (IR)
1.6.3.3 Products that use electromagnetic waves exclusively for other
purposes than radio communication and/or radiodetermination
1.6.3.4 Antennas
1.6.3.5 Amplifiers and other equipment intended to be connected to antennas
1.6.3.6 DVB receivers
1.6.3.7 Jammers
1.6.3.8 Construction kits
1.6.3.9 Specific components (radio)
1.6.3.10 Radio equipment installed in vehicles
1.6.3.11 Fixed Installations.
1.6.3.12 Power plugs attached to radio equipment
1.6.3.13 RFID TAG .
1.6.3.14 Cabling and wiring
2 Obligations of the economic operators
General
Manufacturer
Authorised representative
Importer
Distributor
Description of the manufacturer’s responsibilities
3 Essential requirements
General
Essential requirements applicable to all radio equipment
Essential requirements applicable only to a certain type of radio equipment
4 Interface regulations & specifications
Notification of radio interface specifications
Assignment of radio equipment classes
5 Harmonised Standards
Introduction
Generic harmonised standards vs product specific harmonised standard
Revision of harmonised standards
6 Notified bodies
Introduction
General concept
Annex III procedure — EU-type examination and conformity to type based on internal production control
Annex IV procedure — Conformity based on full quality assurance
Information exchange
Coordination between notified bodies
7 Market surveillance and enforcement
8 Delegated Acts, Implementing Acts and Commission Decisions
Delegated and Implementing acts
Delegated acts
Implementing Acts
Commission Decisions adopted under the R&TTED
9 Other applicable or related EU legislation
General
EU Environmental legislation
Applicability of RED with other EU acts on safety or EMC
General Product Safety Directive 2001/95/EC (GPSD)
Relationship between the RED and LVD/EMCD
10 Comparison R&TTED – RED
Changes between the scopes
Other changes (non-exhaustive list)
What happens with Commission Decisions taken according to
R&TTED?
What happens with the “Alert sign”?
11 Transitional provisions for products falling under the scope of the RED
Applicability of the RED and the new LVD/EMC

Fonte: Commissione Europea

Collegati:

	Descrizione	Livello	Dimensione	Downloads
	RED guide Version of 5 06 2018.pdf EC June 2018	Abbonati Marcatura CE	1568 kB	36